ARECONT VISION AV5245PM-D IP CAMERA DRIVER DETAILS:
|File Size:||26.7 MB|
|Supported systems:||Windows 7/8/10, Windows XP 64-bit, Mac OS X 10.X|
|Price:||Free* (*Free Registration Required)|
ARECONT VISION AV5245PM-D IP CAMERA DRIVER
Open the Dome Cover Prepare Arecont Vision AV5245PM-D IP Camera Waterproof Installation Install the Camera to the Ceiling Step 5: Connect the Cable s Step 6: Access the Camera Live View Step 7: Adjust the Viewing Angle and Focus Step 8: Drill the Holes 1. Using the supplied drill template, mark the screw holes location on the ceiling, then drill the holes and insert the plastic plugs. Determine how the cables will be routed: If the cables will pass through the ceiling: Mark and drill the conduit hole location on the ceiling as shown on the drill template.
Remove the metal cap covering the bottom conduit hole of the camera, and attach the cap to the side conduit hole to close it. Route the network cable to pass this hole from the ceiling. If the cables will be routed along the ceiling, skip to the next step.
Open the Dome Cover 1. Remove the plastic covering the camera.
- Arecont Vision AVPM-D-LG MegaBall G2 5MP Indoor Dome IP Security Camera - $
- Download Arecont Vision AVPM-D IP Camera Firmware for OS Independent
- 5MP IP CAM 3.4-10MM P-IRISLENS
- Shop at the Best Price at the Right Time
- See comparison of Arecont Vision AV5245PM-D-LG with similar Arecont Vision IP cameras
- Specialist IP Camera Store - Supply & Solutions
Loosen the three 3 screws securing the dome cover. Carefully lift to open the dome cover and place it on the side of the camera.
Arecont Vision AVPM indoor MegaBall2 5 megapixel IP camera
Do not abruptly lift the dome cover; it is attached to the camera with a spring wire. Prepare for Waterproof Installation The camera comes with two 2 glands used for waterproof installation: For use with an Exterior-grade Ethernet cable.
Exterior-grade Ethernet cables are already waterproof. Waterproof Solution with Naked Cable on page 6. For use with a flexible conduit.
See Waterproof Solution with Conduit on page 8. Determine the type of waterproof solution that is applicable to your installation requirements and prepare the necessary accessories or purchase extra materials. The bundled conduit gland may vary.
Disassemble the cable gland as shown below: Insert the clamping nut into the Ethernet cable. Insert the sealing insert with claw. Attach the cable gland body to the hole of the camera. If the cable will be routed along the surface, skip this step.
If the cable will pass through the surface, do the following: Pull the network cable through the bottom conduit hole. Insert the sealing insert with claw into the cable gland body and then attach the clamping nut to complete the cable solution.
Make sure the clamping nut is tightly attached to the cable gland body and the sealing insert is squeezed tightly. Proceed with Step 4: Install the Camera to the Ceiling on page Prepare the following materials Arecont Vision AV5245PM-D IP Camera waterproof installation: Disassemble the bundled conduit gland as shown below: In this installation, the conduit gland body can be securely attached to the camera; therefore the use of lock nut is not necessary.
megapixel,AVPM-D-LG,H,MJPEG,MegaBall G2 Series,Arecont Vision. IP Camera with SNAPstream™ (Smart Noise Adaptation and Processing).
megapixel,AVPM-D,H,MJPEG,MegaBall 2 Series,Arecont Vision. 5 Megapixel IP Camera, mm P-Iris Lens w/ Remote Focus/Zoom.